Post 1 made on Sunday August 26, 2012 at 21:47 |
Hawkeye35 Lurking Member |
Joined: Posts: | August 2012 2 |
|
|
I recently purchased a MX-450 and started to setup my devices today. I didn't have any problems with my TV (Panasonic gt30), my Directv, or my XBox. However, my Denon avr1912 has been problematic. After the code screen, when it asks me to test the device, only on and off work. So, I tried to go into learn mode for the volume buttons. The down volume actually worked after learning, but the up volume button isn't working. It says that the function was saved, but the volume won't turn up (it will turn up my TV's volume so the button works). All of the buttons "inside the device" seem to work too. What am I doing wrong?
|
|
Post 2 made on Monday August 27, 2012 at 19:30 |
danieljanderson Long Time Member |
Joined: Posts: | November 2004 219 |
|
|
Either try another code set or be consistent with your learning technique.
When you learn the volume, you may only need a quick blip of signal from the teaching remote, or you may need to press and hold it for a one count.
-Do whatever you did when you taught the volume down key.
|
|
OP | Post 3 made on Monday August 27, 2012 at 21:40 |
Hawkeye35 Lurking Member |
Joined: Posts: | August 2012 2 |
|
|
I went into the audio devices a little deeper and selected the Denon option not in bold. That worked...thanks for your help.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.