| Post 1 made on Tuesday February 28, 2012 at 14:03 |
ltowne1 Long Time Member |
Joined:
Posts: | December 2002
19 |
|
|
I can finally turn on my JVC projector through IP commands with CCP but only with the remote tethered through the screen simulator, not with the remote itself disconnected. Any ideas? I have tried all variations of delays...
IP Macro is (in ASCII):
Delay (.5 Second)
PJREQ
Delay (.5 Second)
!\x89\x01PW1\x0A
Delay (.5 Second)
Add a Carriage return code automatically had to be unselected to make work with simulator.
The delays allow for a PJ_OK upon connection and a PJACK from the projector after I send PJREQ. could it be it is looking for some two-way? I can use the delays in the simulator and it works so I do not see why it does not work on the remote.
|
|
| Post 2 made on Tuesday February 28, 2012 at 14:19 |
adk highlander Long Time Member |
Joined:
Posts: | March 2010
65 |
|
|
Did you go into the program tab and make sure the device signal is set to network?
|
|
| OP | Post 3 made on Tuesday February 28, 2012 at 15:24 |
ltowne1 Long Time Member |
Joined:
Posts: | December 2002
19 |
|
|
adk,
Under RF, then select device, then signal drop down, network? I am not using a base station so this cannot be selected unless you are talking about someplace else.
I am using the IP capabilities of the two way MX-5000 remote. I have it working for a Denon receiver, 4 DirecTV receivers and a Draper screen using a Global Cache IP2IR device and all are set to IR and all work fine except the JVC Projector which only works under the simulator...
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
