Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Previous page Next page Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Page 3 of 3
Topic:
New Dish remote breaks MX-900
This thread has 31 replies. Displaying posts 31 through 32.
Post 31 made on Friday January 18, 2019 at 17:48
JoeFlabitz
Select Member
Joined:
Posts:
December 2008
1,517
NP Ed, I'm impressed you still could find your notes from 2011!
Post 32 made on Saturday October 24, 2020 at 17:40
tadawson
Lurking Member
Joined:
Posts:
July 2004
3
Can't speak to a 723, but the Hopper 3 will accept both RF and IR at the same time (as I suspect all will).

Simply pick channel 1 on both the remote and the URC IR command set (if you even gat a choice) and set the Dish to 1 as well . . . Dish remote on RF, URC on IR, works fine . . .

Not sure where the idea came frkm that it's IT *or* RF . . . that's just not the case!

If you need to run a different codeset, then set the Dish report to IR and the desired number. Learn those commands in the URC, set the Dish back to RF, set the RX to that number and works as well.

Been doing this for years on a 7xx series RX, and nor Hopper3 and Joeys . . . never fails.
Page 3 of 3

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse