Post 1 made on Tuesday November 15, 2011 at 00:02 |
rkaczano Long Time Member |
Joined: Posts: | November 2011 14 |
|
|
I know it is possible to dial-in a specific base station using an MX-350. How do you dial-in a specific LED port within that base station?
I have to two DVRs on a URC 260 Base station. I want to send theses components discreet navigation signals from my MX-350
Example: Choose DVR1 and Cursor Up Choose DVR2 and Cursor Up
I alread have the DVRs set up as two separate Devices. I want to choose them and then have the remote only fire signals to that specific device.
Can you do this via the MX-350?
Thanks
|
|
Post 2 made on Tuesday November 15, 2011 at 15:12 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
page 34 and 35 in the manual explain how to do it [Link: universalremote.com]note that you must have your RFID set to anything other than zero on the basestation for IR routing to work.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.