When I import a device into my MSC 400 and turn that device into a macro group I am having issues with the amount of times that signal is pulsed out from my IR emitters.
If I un-check the "repeat while pressed box" and change the value in the "Repeat" box, it works fine; I can control the amount of pulses the emitters send out, but I lose the ability to hold down the button and continually repeat the command. Specifically volume.
If I check the "repeat while pressed box", and change the value in that box, it only pulses out the command 3 times no matter the value. What am I missing.
AND if I take that command, and put it into a nested macro, no matter what either value is it will only pulse 3 times.
K, thanks for the reply, but I cannot use 232, not available on the units I have. Its across the board for the commands. But the volumes are most annoying. I know its something I am doing wrong
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
