On November 26, 2010 at 04:28, gsoto said...
I am trying to get my MX-450 to control my projector screen which has an IR remote / controller. I have created a new device called screen and tried "teaching" the up, down and stop commands to the remote. It says "Good" and saves the command but when I point it at the screen controller it doesn't work. Any ideas?
I tried programming to soft buttons and even to the ON/OFF buttons but no luck. I even tried making a macro which repeated the command a bunch of times.
I will eventually be using a MRF-350 with an IR flasher pointed at the screen controller so I could try adjusting the IR emmiter strength then but I doubt that will work if pointing the "taught" remote right at the eye doesn't. Thanks for any ideas.
this happens to me all the time, but mostly with cheaper components or appliances with IR remotes. i found out that sometimes, if i continue to relearn the button more than once, it could just start working, but that doesnt happen often. it doesnt matter which base station im using either. its just finicky. My portable AC does this. Half the buttons work but the other half of the buttons wont learn. it will say learn ok, but wont operate that function while other functions learn ok. On the AC, the IONIZER would learn but not work, but the Temperature UP would not work but the Temperature DOWN would work.