| Post 1 made on Monday April 26, 2010 at 16:59 |
Hoping for some help. Have MSC400 and 2 mx980's. Trying to control power to a video switch via the MSC400 relay. Have written smart macro's to trun on and off. When I test the macro's in the MSC400, they work perfectly. I then drag the smart macros into the 980 - I am using the On and Off hard buttons that are used to power on the TV. I get the little purple T on the button in the editor to indicate that is sees the smeart macros. I then save and download to the MSC and the 980 - no errors. But when I try to use the remote to trigger the command - nothing happens - the status light on the MSC400 does not even acknowledge that a button press occurred. Any ideas???
I am using CCP and have been passing many other commands from 980 through MSC400 with no issues - but this is my first smart macro.
Thanks for any help!!
|
|
| OP | Post 2 made on Wednesday May 5, 2010 at 15:08 |
|
| Post 3 made on Wednesday May 5, 2010 at 15:23 |
jbworks Long Time Member |
Joined:
Posts: | January 2010
134 |
|
|
Make sure the device that holds the smart macro is set to use the MSC-400 under the RF control. Its a easy mistake.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
