Post 1 made on Wednesday December 6, 2006 at 12:05 |
relay Lurking Member |
Joined: Posts: | December 2006 3 |
|
|
Hi folks. Hoping that someone might be able to offer some insight or suggestions.
I am having some difficulties getting IR into the MRF-300 from a Global Cache GC-100. The GC-100 is basically a ethernet addressable box that allows a PC to remotely output addressable IR / serial information to multiple devices.
I connected one of the GC-100 IR ports to the MRF-300s IR input. As soon as I connect them the MRF-300 stops functioning for RF. I have connected them properly as the GC is then able to route IR to the MRF-300 which then is output to all IR sensors connected to it. The devices work fine. The GC is outputting 5V. Not sure what the MRF-300 is expecting. Perhaps 12V? Not sure if this might be my issue or not.
Thanks for you help!
|
|
Post 2 made on Thursday December 7, 2006 at 20:53 |
AnthonyZ Select Member |
Joined: Posts: | September 2005 1,987 |
|
|
I think you need the GC-CGX IR converter cable. Visit www.globalcache.com.
|
"Just when I thought that I was out they pull me back in" |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.