Post 1 made on Tuesday April 1, 2008 at 20:06 |
themissinglink Long Time Member |
Joined: Posts: | November 2006 32 |
|
|
Have an MSC400 and I'm trying to reliably control a Panasonic TH-42PH10UKA Plasma.
Have the right Serial cable from the MSC to the Display's Serial connector, And I have turned on the Serial Function in the Display's menu. Tried testing some of the basic commands (power and input) but no luck.
My Integra Receiver works fine via Serial control, connected to the same MSC.
Anyone have a fix?
|
|
Post 2 made on Tuesday April 1, 2008 at 20:46 |
J.Todd Long Time Member |
Joined: Posts: | August 2007 481 |
|
|
|
Post 3 made on Tuesday April 1, 2008 at 22:51 |
Glackowitz RC Moderator |
Joined: Posts: | May 2002 3,793 |
|
|
did you tie pins 7 and 8 together on the plasma side??
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
OP | Post 4 made on Saturday April 5, 2008 at 09:04 |
themissinglink Long Time Member |
Joined: Posts: | November 2006 32 |
|
|
Null Modem Adapter from the Crack Shack, and all is well in the residence.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.