Post 1 made on Wednesday October 24, 2007 at 21:34 |
G Grant Lurking Member |
Joined: Posts: | October 2007 3 |
|
|
When adding a new component to my setup last night my950 just froze when I got a low battery warning.Now it wont transmit any signals.Have tried removing the battery which is now fully charged "no good".All lights etc seem to be ok have also tried manual learning and it all seems ok but it refuses to operate any of my equipment even the old stuff.Did factory reset and started new setup still won't transmit any signals.Any help would be great thanks.
|
|
Post 2 made on Thursday October 25, 2007 at 10:54 |
Malcolm013 Long Time Member |
Joined: Posts: | November 2004 461 |
|
|
You sure it's putting out IR?
|
"Was it for this my life I sought? Maybe so, Maybe not...
|
|
OP | Post 3 made on Friday October 26, 2007 at 05:30 |
G Grant Lurking Member |
Joined: Posts: | October 2007 3 |
|
|
According to a test I did by aiming the remote into a digital camera it is not transmitting IR.Have tried recommended methods by URC -factory reset.download default configuration then reload original config.Still nothing.Maybe the remote is history.Don't know what else to try.Any help would be great thanks.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.