Your Universal Remote Control Center
Philips Pronto Classic Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 15 made on Saturday May 1, 2010 at 08:22
IR Expert
September 2002
On April 30, 2010 at 01:06, Ernie Bornn-Gilman said...
There is no such folder. Are you (not) saying I should create a folder with that name? I'll try it.

IRCodesCreate.ccf is not a folder. It is a ccf file that will be created by IrPanels when IRPanels works.

If may not be obvious when IRPanels has worked, so you need to look to see if it has created that file.

You need the file IRCodesMaster.ccf (from the IrPanels zip file) to be present in the directory from which you run IRPanels.

IRPanels has no specific expectations about where it will be installed or run, just that the current directory when it is run will be the location from which it reads IRCodesMaster.ccf and to which it writes IRCodesCreate.ccf. There are many ways to run a program in Windows, with different effects on the choice of current directory while the program is run. But the normal GUI method to run a GUI program will cause the current directory to be the directory containing the program itself.

Runtime Error '5.'
Invalid procedure call or argument

Unfortunately, IRPanels has error messages like that for many reasons. Some reasons may be your errors (not having IRCodesMaster.ccf available or using hex labels in makehex instead of decimal labels). But sometimes IRPanels just doesn't like some perfectly correct timing data in the Pronto Hex. That can be very frustrating to debug.

Last edited by johnsfine on May 1, 2010 08:29.

Hosting Services by ipHouse