Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto Classic Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 4 made on Wednesday April 28, 2010 at 18:44
Ernie Bornn-Gilman
Yes, That Ernie!
Joined:
Posts:
December 2001
27,151
I've run Decode ccf, and I have the Excel file that says NEC, Device 0, etc. All learned codes are very consistent re frequency and reps, so it looks like I had pretty good learns.

Next, I see I can generate perfect codes from an irp file, but I don't see how to make the irp file. Plrease -- how do I do that? I think I looked at all the readmes and I did not see any instructions about that.

If I'm right, I would thenuse MakeHex, then Hex2ccf, to create a ccf with the actual codes so I can try them out.

I am shipping the controlled item out on Monday or so, so I'm hoping I can get this done today or tomorrow.
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw


Hosting Services by ipHouse