On October 16, 2009 at 09:19, joe sexton said...
This will repeat the individual commands but not sustain so the ramp will be slow: create macro, drag "repeat steps" command into the workspace, put your 2 volume commands into the "repeat steps" command. Make sure "Until button is released" is selected.
This can work pretty well with serial but not IR so much. On the Yamahas we use, they can process volume +/- faster than is comfortable for a volume ramp, so
Z1 vol+
wait 0.1
Z2 vol+
wait 0.1
Repeat above until button released
works pretty well when you need to "join" zones.
