On December 30, 2006 at 20:39, ddarche said...
Marc,
I would change the ID on the extender. When I was working
with a 9400 recently, which would not connect, I changed
the ID to 1 and back to 0 and all of a sudden, it began
working fine.
Not sure if it was not really set to 0, but once I switched
it to 1 and then back to 0, it began working fine.
Dave
Thanks for the advice. I switched from, and back to, "0". I also tried switching it to "1" and leaving there. It didn't help.
Marc
