I have been trying to setup my RFX9600. I haven't had luck. The extender detector just keeps searching and doesn't find the extender. I have hooked up the laptop to the RFX directly and used the browser setup. It is set to HDCP. Should it be set to a fixed IP? Perhaps I simply don't understand my network set up well enough. My TSU9600 is successfully communicating with my network via the wireless access point, based on the fact that it says it is communicating and can run my Escient Fireball.

I have the system properties set up to use the extender. I have the ID on the back of the extender and the ID in the properties set to "0". In the setup I have tried it with the extender IP address and without the address. I have connected an IR emitter to an output on the back and then selected that IR output and the extender in a device and tried sending IR commands to that device. However, my panel simply says, "command failed". Can anyone help walk me through this?
Thanks,
Marc