Hi folks,
I got my TSU9600+RFX9600 setup OK but no even one IR is working.
Here my config:

TSU9600 connect to a WLAN Router (WLAN sign,SSID + IP in the TSU is OK)
Router connected to the RFX9600. (Ethernet LED on RFX is green)
I can ping the RFX from my notebook over wlan so thats fine too.(using fixed IP 192.168.0.42)

I connected the IR Ports from the RFX to my Pioneer devices via the mono cable.
I programmed the tsu using the factory db for the devices.

The device properties are set to Extender 0 and the correct IR port for the device.

Still got my Notebook connected via the USB cable to the TSU but no even one IR code is send to the RFX using the fast IR test. The Tsu says "sending" but no LED at the RFX is flashing, no action at the devices...nothing. Also after uploading of the config to the tsu nothing happens.

What the hack I do wrong???
Any help on this would be appreciated.
Sascha