On October 26, 2008 at 07:26, PS2 said...
Unless I am mistaken, to add a power sense condition to
the action list, an extender needs to be enable for the
device. This means that IR will go through the extender
and IR emitter needs to connected to an IR port and attached
to the device (or an IR cable needs to be used).
An alternative would be to use ProntoScript to test the
power sense condition and built the conditional logic
required. In this case, an exterder does not need to be
enabled for the device.
Is my understanding correct?
You are correct.
With PS, you can access any extender and port you want. However, note that the Extender "still" applies for any IR codes that are sent. The Activity where the code is located (PEPv1) will control how IR is output.
