On October 15, 2006 at 01:22, GregoriusM said...
I'm having roughly the same problems. I just can't be
sure that a button press will send out the IR code. 99.99%
of the time it shows on the LCD screen that it has gotten
the button press, or if I turn on the beep, it will beep,
but the code does not get sent.
I thought the symptom in this thread was when you press a button it does not show on the LCD that you pressed a button and it does not beep. I would look at your RF if your remote is showing a press and beeping but nothing is happening. I have not seen a lot of failures on my 900 but every failure I do see is no beep and no LCD change and consequently no command. I have never had my MX-900 beep with no command issued.
