| Post 5 made on Monday December 18, 2006 at 00:45 |
Dave E Long Time Member |
Joined:
Posts: | September 2005
282 |
|
|
As GaRder45 stated, if the IR or RF does not go through then the variable changes state but the device does not. Then you have a problem. Using the new MSC-400 would solve this problem because it has video and voltage sensors that know if a device is on or off. You can use IF/ELSE statements to say, "If it is on, turn it off, else, do nothing". That would seem to be a fairly bullet proof solution. Variables will work perfectly if everything else works perfectly. In my world, Murphy’s Law follows me around like a shadow.
| |
|
Experience is what you get when you don't get what you want.
Any wire cut to length will be too short.
I must be a near GENIUS. All my teachers told me I was at the very PEAK of the bell curve! |
|
