Post 1 made on Saturday June 21, 2008 at 18:14 |
ControlCrzy Lurking Member |
|
|
Just purchased a MX-810, registered, and downloaded software.
All programing went well "I think".
When I went to write it to the remote, it needed to install a new USB driver, for the remote to connect with the pc, all appeared to go well, and it seems to see the remote fine. When I do the write to remote, I get a box that says Disconnected, Please try again [EC2].
I've tried re-booting the computer, to no avail, and the error message just seems to think I should keep trying, with no suggestions
Any experience with something like this, or suggestions.
It is version 1.2.027
Thanks
|
|
|