On 11/10/05 19:00 ET, culverinc said...
I'm having trouble with WiFi after installing
the firmware update. I'm able to send commands
from the emulater just fine, and on the NevoLink
settings page in the emulater, my NevoLink appears
in the Assigned NevoLinks box. But on the remote
the NevoLink appears in the Assigned NevoLinks
box with an exclamation point and the MAC address.
The white paper said this is because the device
was busy during discovery. I've tried the refresh
list button and resetting the remote, but no luck.
This worked fine before the update. Any ideas?
Dennis
Are you talking about FW upgrade on the AccessPoint? If so they usually add features or over-write your settings during this process. Make sure you set the parameters described in the whitepaper on mynevo website about NevoSL networking. some things to consider:
1. The AP should be running in Mixed mode.
2. QoS should be disabled and ACK mode should be set to immediate.
3. Security parameters should be double checked( MAC filtering, WEP or WPA...)
4. Trying removing the old AP setup from NevoSL, re-add it and reset NevoSL.
5. Make sure you have ONLY one DHCP server on your network and make sure your NevoSL is getting a valid IP.
again, these are only a few possible resolutions, but the whitepaper is complete.
