Hi everybody, purchased a new Nevo Q50. I am fairly new to programming remotes. Followed all of the directions on manual. I have a Yamaha RX-V2700 receiver I am trying to program my Q50 for. Went to the “Use model based set up”. It listed the RXV2700. I downloaded the device configuration it recommended. Hardly any of the buttons where the same as on my original remote. I made all of the button and label changes then went to advanced key section added, learned all of the additional codes I needed and added them. After I finished my remote and the emulator showed that all buttons were putting out a signal and appeared that everything was working properly. The whole process seemed to go smoothly and felt right until I tried the remote out with the RXV2700. 2 buttons worked. Power on and Power off. No other button work including and hard keys. Any suggestions as to what I did wrong?
