Just received my video sensors and having trouble getting them to work properly. I have a Panasonic SA HT900 HTiB that i am using for my audio which doesnt have a discrete on/off code which is what led me to by the video sensor. I placed the sensor on the video out of the HT900 and setup the if/then statement in my power macros however no matter what i do it always says its on?
Here is my Power On macro:
If
Nevo Video Sensor
Then
Send Panasonic Audio
Else
Power Off:
If Nevo Video Sensor
Then
Send Panasonic Audio
Else
I thought it might have been that my HT900 wasn’t sending out a signal so i tried my tv with the same results. Always evaluates to sending the power on state. Any ideas?