On 10/12/05 02:04 ET, Peter Dewildt said...
If there is exactly one action on a button, it
transmits as long as you press it. If there is
more than one action, each code transmits for
a fixed amount of time, which might not be enough
in your case. Changing the duration would change
the fixed amount of time that it transmits.
Peter
That makes sense, except it works fine on the new pcf, with or without other commands in the SAME macro. Same hex code on the buttons of either old or new pcf. Old pcf only works with the one command.
That's what's so wierd.
Is there any other possibile cause, besides the software?
Since others have had a similar result, I'm going back to the last version firmware and see what happens.
I'll let you know what happens.
Dan