On May 11, 2007 at 15:20, johnsfine said...
Any idea what is going wrong?
I don't think these signals should be hard for an ordinary
learning remote to learn. (As described above, I think
the problem Chuck had is in the Pronto to PC connection,
not in receiving the IR signal).
Don't you have a learning remote and an original remote?
Why did you need customer support from Harmony at all?
As soon as I know for sure where that missing burst goes,
I will know the device code needed to generate a clean
set of these signals with MakeHex.
I was using an older remote to learn the commands, and their older remotes apparently can't learn high frequency codes very well. Luckily, I have a newer Harmony upstairs which should be able to do the trick. If it doesn't, then these hex codes will definitely be helpful.
