Your Universal Remote Control Center
Philips iPronto Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 11 made on Sunday April 4, 2004 at 20:12
Lurking Member
December 2003
Hello Everybody,

It makes me feel alot better knowing i have the support from all of you. I've been harboring these unsolved problems for sometime. It is very soothing to have such a quick and intelligent response from all of you. I thank you and I thank RC's Forum for the support for not having to go at this alone. You guys are great.

My learned if address for my projector's "Power" button is 900A 006D 0000 0001 8615 14EB. I went to the database files on Plus projector and there is Power Off and Power On commands but it didn't pull up the codes in the address.

I did try to sequencing the command rapid fire manually as well as from the macro to no prevail. The guys at Pronto, I might add, refer to this site quite often for solutions they don't have the answers to. Them, as well as I, have a deep respect for you and your inputs. Don't think for a minute they are not viewing, and they should, every comment posted here. Pronto Help Center said you couldn't make the button hold down. Said try the delay and the sequence of same command and if that don't do it then from there knowledge it can't be done.

Here is the learned if command for the Curtains "all open" :
0000 006B 0000 0012 004C 0028 0012 0028 0012 0028 0012 0028 0025 0015 0012 0028 0012 0028 0012 0028 0012 0028 0012 0028 0012 0028 0012 0028 0025 0015 0012 0028 0012 0028 0012 0028 0025 0015 0012 01F5.
I'm having the same problem in opening curtains in my "admit One" macro button. This is the button customer will press to turn everything on. When this command goes out curtains nudge forward for a millisecond and stop.

I even tried to make a button for powering on projector and placing it over the "Admit One" macro sequence (which I delayed 3 seconds) and then putting it in the background. Thought maybe if customer hold down button for 2 secs it would turn on projector and then go to the Macro sequence. Didn't work. But again I'm programming at home and then trying at customer's house. I will try to make some buttons with different commands for power on projector and try them tomorrow. If anybody can help with this code I posted still much appreciated.


Though not ready for Primtime I will upload my remote's icf in thid forum.

Hosting Services by ipHouse