Post 3 made on Saturday April 3, 2004 at 16:12 |
popcorn Lurking Member |
Joined: Posts: | December 2003 8 |
|
|
Thanks Kees,
I tried that and it wouldn't work. However the remote is here at my house being programmed and then carried to his house to see if functioning. I thought the "delay' button was use for time spacing between each command if given in a series. your saying "delay added" is how long the button is to be pressed or activated before releasing it and then going to next command and not the actual time, though relative, between the next ir command being sent. And just to make it clear, is this delay put in the macro after "proj power" then delay 2 sec. or place in the projector's main page for the power properties when pressed. I'm assuming the later being i had not put it there before only in th e macros. Thank you I know it seems like a base question and i know i tried all this but i had a lot of issues early on (remote wasn'tlearning commamnds etc etc). I'll try it again!
|
|
|