The following page was printed from RemoteCentral.com:
Post 3 made on Sunday April 16, 2006 at 04:56 |
satscan Long Time Member |
Joined: Posts: | August 2005 14 |
|
|
I also use Marmitek/X-10 because EIB is too expensive.
The iPronto only has a 802.11b PCMCIA card for wireless communication to the access point.
Out of the box the iPronto can only transmit/receive IR but it's easy to add RF capabilities. There are small transmitters available that can be run in parallel to the IR output. The same modification is being used to extend Prontos without RF capabilities.
You will need a RF to IR converter for the iPronto to learn X-10 codes or you do it by additional software.
|
|
|
|