I bit the bullet and created an ICF for my DVR remote by creating a series of buttons on a page, send that config to the iPronto, teaching the iPronto every button, then getting the Config back into Pronto Edit. But now I can't create multiple IR commands in a button.
1) I create a new Config
2) I create a button
3) I go to Properties of the new button and under Action, I 'Add An IR Code'
4) I close the box and try to do Add An IR Code again but everything is greyed out/locked.

What am I missing here?
I want to create button for specific channels. The command set should be something like:

Digit 2; enter
or
Digit 0, digit 0, digit 2

I can add the Delay, add a Beep, etc. But I cannot add another IR command.

What am I missing?

Thanks!

Dave