Your Universal Remote Control Center
RemoteCentral.com
Philips iPronto Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Tuesday July 3, 2007 at 20:05
mburwen
Founding Member
Joined:
Posts:
August 2001
1,185
I'm sure this is old ground, but I need some help. I've had an iPronto for some time and just got a NetX device. Have done all the things I think are required to get the wireless system to operate properly, but it does not.

The NetX appears to have been installed properly - the light switches from red to orange after configuration setup and the right data appears on the NetX setup screen on the iPronto.

In the editor, I changed IR to RF in each Device Properties page and Pressed 'Auto Detect' which appears to work every time. I then downloaded the icf file into the iPronto.

Not only does the RF not work, but the IR commands still work! I haven't been able to find out if that is OK or not. Does anyone know if enabling the RF is supposed to turn off the IR? If so, seems probable that the firmware is not interpreting the RF mode. In any event if anyone can shed light on this, I'd appreciate it.


Hosting Services by ipHouse