Your Universal Remote Control Center
RemoteCentral.com
Harmony Remote Controls Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Saturday February 28, 2004 at 19:27
Hemway
Lurking Member
Joined:
Posts:
December 2003
3
I recently purchased the SST-659 and I want to use it to control my Sony KP-53HS10, my Dish Network 811 receiver, and my Dish Network 501 receiver.

I have the 811 standard audio/video connected to the Sony’s video4 port, and the HD component video/audio connected into the Sony’s vidio5 port (HD).

I have the 501 standard audio/video connected to the Sony’s video4 port.

Because the 811 and 501 are in the same rack, I had to set the 811’s receiver and remote to ‘Remote ID 1’, and the 501’s receiver and remote to ‘Remote ID 2’, otherwise when using either of the remotes, it would control both receivers at the same time.

I’ve gone out to the Harmony site and added all of my devices, and set it up so when I watch TV, it turns on the Sony, turns on the 811, and sets the video input to video4. This works fine. I’ve set up an activity to watch TV via the 501, by it turns on the TV, sets the video input to video1, turns off the 811, but doesn’t turn on the 501.

Is there a way to program the Harmony so when it switched to control the 501, it sets the Remote ID to 2?


Hosting Services by ipHouse