Post 2 made on Friday April 18, 2008 at 09:57 |
akirby Super Member |
Joined: Posts: | March 2004 4,640 |
|
|
Instead of learning new codes for MCE - did you try the "Confirm Infrared Commands"? If all you did was change the remote address this will ask you to send a few test commands and it will automatically choose the right IR codes for that address (if they exist). Add a new MCE device and try that - using the remote that's already been set for the new address. I bet that gives you back the Aspect command since they normally just copy all the commands to the different IR addresses.
|
|
|