Program the remote to send direct functions:-----------------------------------------------------
1) Set the layer switch at the top to the CABLE/DBS/DTV postition.
2) Press and hold the POWER button. While holding the power button, use the number buttons to enter the code 198.
The following buttons will change functions:----------------------------------------------------
POWER = Power ON
STOP = Power Off
PAUSE = AV Reset (same function as front panel)
Discrete Inputs: Press DEVICE UP then press the key listed below:-------------------------------------------------------------------------------
1 = Input 1
2 = Input 2
3 = Input 3
4 = Input 4
5 = Component 1
6 = Component 2
QV = VGA
PIP CH UP = ANT-A
PIP CH DN = ANT-B
PIP or PIP/POP = ANT-DTV
PIP INPUT or PIP DEVICE = Input DTV
NOTE: When using this remote as an original source remote to program a "learning" remote, the DEVICE UP button does not send a signal! It is used simply to prepare the remote to send the correct input signal when the following button is pressed.
Return the remote to normal consumer functions:----------------------------------------------------------
1) Set the layer switch at the top to the CABLE/DBS/DTV postition.
2) Press and hold the POWER button. While holding the power button, use the number buttons to enter the code 197.
Last edited by Smokey12777
on February 4, 2006 07:36.