Page 53 of the MX3000 Manual
Using Variables for Toggle Only Acuated Devices (TOADS)

There is a variable value you can place into the MX3000 so that when you turn the system on it gives value to a variable of 0 or 1

Example Macro for on....Piece A on, Piece B on etc etc

set value of variable to 1 for projector.....
When value =1 then projector is on or whatever you decide
then when you give another command it will check the variable value and not issue a power command for the projector unless the value is 0 only when you issue an off macro or such that you place a value of 0 in the variable will the projector react

Its nice for TOAD pieces....

check out page in the manual for help or just ask.

CI

This message was edited by chicagoinstaller on 11/01/05 18:00 ET.