I am finishing up an install where I have one Dish Network 811. I am taking the component output of the sat rcvr to a CELabs COMP400 and then sending it out to 2 TV's in other parts of the house as well as to the component in on the Yamaha RX-V757. The Component out to the TV's works fine through a couple of MuxLabs Component Baluns.
The problem is that the component out of the CELabs to the Yamaha rcvr will not pass thru. If I go straight from the 811 to the Yamaha rcvr, it works fine. Once I connect it thru the CELabs Amp, I get no video.
Would it be wise to put in "y" patch cords at the 811 and send one side directly to the Yamaha and the other side to the CELabs Amp?
Any other (cost effective) solutions would be appreciated.
Thanks
Chris