Your Universal Remote Control Center
RemoteCentral.com
Sony Remote Controls Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 5 made on Wednesday January 29, 2003 at 18:11
teamgs
Lurking Member
Joined:
Posts:
January 2003
5
Per Sony,

Description:
The Receiver Does Not Respond To The Supplied RM PP411 Or RM 306 Remote Control.

Solution:
IMPORTANT: This solution only applies to receiver models HT DDW740, HT DDW840, STR DE485, and STR DE685.

If the receiver does not respond to the supplied RM PP411 or RM 306 remote control, the remote control command mode may need to be set up on the receiver.

To set up the remote control command code on the receiver, please follow the steps below.

On the front of the receiver, push the SET UP button.
Press the left (<) or right (>) directional button until the display on the front of the receiver reads C.MODE.AV1 or C.MODE.AV2.
NOTES:

If C.MODE.AV2 is displayed, the receiver is setup properly.
If C.MODE.AV1 is displayed, follow step 3 below to change the code.

On the Jog DialTM control, press the plus(+) or minus(-) button until C.MODE.AV2 shows in the display.
NOTE: Depending on the receiver, the plus(+) or minus(-) buttons may not be available. Instead, press the top or bottom of the Jog DialTM control. Please refer to the Operating Instructions of the receiver for additional information about the Jog DialTM control


Gary


Hosting Services by ipHouse