Troy,

If you don't need any more memory, and have used up most of the memory available, then you're doing great. The worst thing to do is NOT use memory you've paid for.

Do you not know how to USE advanced codes, or just not how to FIND advanced codes? Basically you can TRY the numbers between 000 and 255 in the following sequence...

Turn ON your receiver.
Press SETUP.
Enter the 3 digit number.

If anything happens on the receiver, MAKE A NOTE OF IT! You'll need the number you just entered later.

Once you've got a number you want to program permanently into a key, then use the following sequence...

Press the DEVICE KEY you want the advanced code programmed into.
Press and HOLD SETUP until the LED blinks twice.
Enter 994. You should again get two blinks.
Press SETUP.
Enter the 3 digit advanced code.
Press the BUTTON ON THE REMOTE that you want the code programmed into. You should then get two blinks.


If you get a single long flash of the LED instead of the expected two blinks, then your sequence has failed, and you'll need to try again. If successful, the button should now call the programmed function when you push it in that device mode.

Good luck,

Dave