Your Universal Remote Control Center
RemoteCentral.com
One For All & Radio Shack Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 2 made on Monday January 27, 2003 at 08:32
johnsfine
IR Expert
Joined:
Posts:
September 2002
5,159
Without looking at your post in an earlier thread, I wouldn't know 1023 referred to "Pioneer Receiver (code 1023)".

Even looking there, I don't know what "the table" means. I also don't know what you mean by "Button ID's". I doubt that you mean what that phrase would normally mean in a JP1 context.

I do know that setup code 1023 uses 2-byte hex commands, so you can't use advanced codes for it without JP1. If you're using JP1, you should ask the question in the Yahoo group and provide a little more detail.


Hosting Services by ipHouse