Your Universal Remote Control Center
RemoteCentral.com
Intermission Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 21 made on Tuesday August 19, 2008 at 04:28
Mr Griffiths
It's my lucky day!
Joined:
Posts:
February 2005
2,678
Samsung are usually 0060 065, 584, 037, 245, 476, 398, 516, 292, 318, 037 BUT

Step and set (if you cant find the code)
1. First Set the remote control to the TV Mode, then turn on the TV that you want to operate.
2. Press and hold the Select and Red keys simultaneously on the remote control for a minimum of 1.5 seconds, until the LED blinks twice. (This enables the "ID Code" programming function in the remote control.)
3. Press and release the TV key. (This enables the "step and set" feature.)
4. Aim the remote control at the TV and press the On/Off key. The TV should turn off (or go to standby).
5. If the TV does not turn off, press and release the TV key and repeat step 4. When the TV does turn off, got to step 6.
6. Press and release the Select key to lock in the ID code that operated your TV. The LED will blink twice after pressing Select to indicate that the code was programmed.
Once the unit goes through the entire memory of ID codes without selecting an ID, the LED blinks three times and the unit exits the Step and Set Mode.
(The next time this sequence of steps is initiated, the stepping will start from one ID above the ID used in step 6, allowing the user to cycle through the remaining codes in the device library.)
Note: Once the On/Off key is pressed right after the TV, the remote will not react to any other key presses but the TV and On/Off. However, if a digit key is pressed right after the TV key the unit will automatically enter the Brand Step and Set Mode.

Find out which code your remote is using
This procedure is used to establish which three digit code has been programmed into the Sky Remote.

It is useful to find out which code is being used so that the same code can be re-entered when batteries are replaced or the RCU loses the memory settings for any reason.

1. Press the TV button on the Sky Remote Control Unit.

2. Press and Hold down the Select and Red buttons simultaneously on the Sky RCU until the LED blinks (flashes) twice.

3. Press the numbers 9,9,0 on the Remote Control Unit.

4. Key in 1 on the RCU and count the number of times the LED blinks. The number of blinks will indicate the first digit of the code.

5. Key in 2 on the RCU and count the number of times the LED blinks. The number of blinks will indicate the second digit of the code.

6. Key in 3 on the RCU and count the number of times the LED blinks. The number of blinks will indicate the third digit of the code.

Once the 3 digit code has been identified, the Remote Control Unit can then be reprogrammed using the Direct Set procedure.


Hosting Services by ipHouse