I do believe Nick is correct. I looked it over myself. And I found nothing about rf to ir. Just IR. I even looked at the "trouble shoot" pages at the end. And under
Devices do not respond to the commands I send
Make sure to point the iPronto’s sending eye towards the device.
Make sure there is no obstruction between the iPronto and the device.
Check the battery status in the status display or in the General tab of the System Settings.
Check if your device understands Philips IR codes. You can find this information in your device’s manual. If your
device does not understand Philips IR codes, you can learn the IR code from the conventional remote control.
See Learning IR Codes on page 38.

Which it says nothing about the 801.11 station or whatever you want to call it.


However, I didn't see anything pertaing to the wireless network. Which doesn't come with the ipronto. However, there is a link in there..... [Link: pronto.philips.com]

In case any of you would care to have it. But realize this, it's just a tease due to the fact the site is not avaible yet.

Rob