Post 1 made on Monday June 4, 2001 at 06:37 |
Stefan Antwarg Historic Forum Post |
|
|
Hey,
I have a visor platinum and have just installed omniremote. Seems really good but I have few problems with it.
1. When doing macros, one of the steps I want to set up is changing my video source. One button on my original TV remote switches from tv, to Video 1, to Video 2. If I set up the macro to press this button, most likely I will not get video 2. Is there a code or something I could input into omniremote so it always goes to video 2? I have a Sanyo 25" direct view tv (txe2545)
2. Volume. I have tried training the volume button by holding the volume and by pressing it quickly. Apparently the infrared beam will not transmit a rapid signal to move volume up and down when you hold the stylus on the volume button. The only thing I have come up with is to train it by pressing volume quickly. Then when you hold the volume down, the pda emits a steady infrared stream. The problem is that it is very slow.
Has anyone experienced any of these problems?
Stefan Antwarg
|
|
|