On 10/23/05 21:52 ET, rciiuser said...
I am using an Axim x51v
When using a single button or a single line in
a macro turning on the power to my Daewoo monitor
works fine. However using a macro with multiple
commands the power on or off does not work on
the Daewoo, the other commands in the macro work
fine.
Any suggestions?
I assume that the power command is disturbed by the folowing IR- command.
I suggest to add a wait- time of 200ms after this command in the macro- list:
[Link: wincesoft.de]Frank
www.WinCESoft.de
