Post 16 made on Wednesday June 20, 2007 at 20:57 |
SAAudio Advanced Member |
Joined: Posts: | March 2007 993 |
|
|
Damn, I got started programming the T4 and was really rocking at first. Got ready to test some of the programming and ran in to my first issue. I am using a RP6.
When I send commands from the T4, i was getting nothing. Figured I would go through programming and make sure all the RF properties were set properly. Couldn't find an issue. Then I went to make sure the rp6 had usb unplugged because i was getting confused. When I stand within 5 ft of rf antenna, it works perfectly. If I move away, nothing.
When I press a button near the rp6, the antenna flashes green and works well. When I press a button away from the rp6, it flashes red.
I read a couple of old threads about others having issues very similar. Do I have the same problem or should I try something else?
Man, this sucks. All excited and it appears I will have to wait until this gets switched out. Please tell me there is something I am missing.
|
|
|