Post 1 made on Friday June 29, 2007 at 06:45 |
Oz AVI Senior Member |
Joined: Posts: | November 2004 1,151 |
|
|
This afternoon I was at a clients installing an Escient Fireball SE80i, all works fine with the Standard remote but when I loaded the commands into the T2C (RP6 also) the only commands that work are the cursor/scroll up and down. Nothing else works! As it was last thing Friday afternoon, I took a shortcut and used an emitter over the IR window, intending to return early next week to wire in via the IR port on the back. I did try varying the output level on the RP6.
When I got home, I've got a Escient Fireball SE160i of my own (one week old) that, once again I've been using the standard remote until I get around to programming my T2C, I figured that now was the time to program it! Thought I would set it up in 'stand alone' mode, and same thing! Scrolls up and down, but nothing else. Tried altering repeats, still no good. Any ideas?
TIA Iain
|
|
|