On July 20, 2007 at 08:08, vbova27 said...
Guys, I had a problem with an install last night and was
wondering if anyone had the same results and what caused
it -
The first problem happened when I noticed there were some
bad IR codes for the client's DVD/VCR Combo. I quickly
dvd vcr comb......problem# 1
learned them off the actual remote into the library, and
for some reason, my response from my IR pro was kind of
lousy. I never get errors when llearning, yet one of
the codes had errored and eventually learned, and the
reset seemed to have learned in very quickly. It was
how were the remotes batteries?
not right. After I had placed the codes on the remo ote
and synched, whenever I pressed one of these codes ALL
of the IR emitters held a steady red, the high out went
on the RP-6 and it would not accept any more commands.
I had to reboot the T3, but whenever I pressed these
codes, same thing. I re-learned the codes back in a second
time , it went smoother and the poroblem went away. Anyone
know what caused this strange thing to happen?
sounds like operator error of some kind
Another problem I am having is that for some reason all
the emitters hold a steady red sometimes. Is this an
interference issue? The RP-6 is in an equipment closet
along with the RM-433 which is distnanced as much as possible.
(this is a theater room).
get the rm433 out of the closet or away from the equipment..... the equipment will mess with the rf
i think you need to take some rti training at the local supply house.
When I left last night everyhting seemed to be working
good - I just want to figure out why these things were
happening in case they do occur again.
Thanks
how many rti remotes have you done?