On September 25, 2007 at 01:54, fluid-druid said...
I didnt' read all responses so this may be duplication,
but I think I see the error.
Where are the flags being SET? I see 2 flags ("Zone
1 ON" and "System ON").
Is it possible that the "System Macro: Zone 1 ON" macro
SETS the "System ON" flag?
If so, the next line, which test for the "System On" flag
will ALWAYS be true.... and the delay will never happen.
Nice call. I think that may be the issue. I will test the process again and I will immediately eat my words if that was the issue.
Also, the "Zone 1 Start Volume" is outside of the If/Else
brackets. Therefore it will ALWAYS run no matter what.
This is desired because it is still within the else statement of the zone 1 on test. The zone 1 start volume is always set when zone 1 is powered on regardless of the system state.
Another thing: Are you sure that your receiver doesn't
have a setting for Power On Volume? I know the Denons
do.
