Post 17 made on Tuesday September 25, 2007 at 01:54 |
fluid-druid Senior Member |
Joined: Posts: | June 2005 1,312 |
|
|
I didnt' read all responses so this may be duplication, but I think I see the error.
Where are the flags being SET? I see 2 flags ("Zone 1 ON" and "System ON").
Is it possible that the "System Macro: Zone 1 ON" macro SETS the "System ON" flag? If so, the next line, which test for the "System On" flag will ALWAYS be true.... and the delay will never happen.
Also, the "Zone 1 Start Volume" is outside of the If/Else brackets. Therefore it will ALWAYS run no matter what.
Another thing: Are you sure that your receiver doesn't have a setting for Power On Volume? I know the Denons do.
|
|
...couple a thumb tacks and a stick of double sided tape should hold this baby up... |
|