Looking to see if I can use this configuration or is there an easier way to do it.
I have an XP8 and a UPS which sends out a learned IR code via a 3.5 blaster port when it hits a certain percentage of battery back up time after the power fails. This IR code is usually used for projectors.
Can I hook up a ir emitter to the blaster port and stick the emitter end onto a MS210 (IR sensor) then connect the ir sensor leads to the XP8 with the ground, positive and data wires. I assume these wires would go into the same molex connector on the XP8 as the RM433. Then could I convert the Macros on the XP8 to IR trigger codes, and dump the appropriate ir trigger code hex into a RTI remote sending standalone ir codes out then learn them to the UPS? Does this work, has anyone tried it or is there a better way.
The reason I would like to use the trigger codes is so the can maintain status of the flag for the projector power.