I am using a Streamzap remote to control a PC media player. However, I've learned the RC5 codes on an RC9200 but they don't show up as RC5 but rather the normal Pronto Learned format. My preference would be to know the actual System/Command that is required to generate the command. Why? I'd rather have clean RC5 codes than potentially unclean learned codes.
I've picked up the information below off a website and was wondering if someone could translate the timings into a valid RC5 System/Command code that I could enter in TSS/PE.
Thanks for any help you can provide.
Lyndel
# brand: streamzap # model no. of remote control: # devices being controlled by this remote: #
begin remote name streamzap bits 6 flags RC5 eps 0 aeps 300
one 768 768 zero 768 768 plead 768 pre_data_bits 8 pre_data 0xA3 gap 65280 toggle_bit 2
begin codes 0 0x00 (NOTE: RC5000i learned code below) 1 0x01 2 0x02 3 0x03 4 0x04 5 0x05 6 0x06 7 0x07 8 0x08 9 0x09 Power 0x0A Mute 0x0B ChUp 0x0C VolUp 0x0D ChDown 0x0E VolDown 0x0F Up 0x10 Left 0x11 OK 0x12 Right 0x13 Down 0x14 Menu 0x15 Exit 0x16 Play 0x17 Pause 0x18 Stop 0x19 TrackPrev 0x1A TrackNext 0x1B Record 0x1C SeekBack 0x1D SeekFw 0x1E Red 0x20 Green 0x21 Yellow 0x22 Blue 0x23 end codes