| Post 6 made on Thursday November 20, 2003 at 09:40 |
Eigeny Oulianov Founding Member |
Joined:
Posts: | October 2001
238 |
|
|
DON'T TRY to connect something except IR flashers into RF extender output directly - it may damage the connected device!
It is a cheme of RFX outputs (2 pairs):
+9V ---\
>JACK======LED+LED(in series)
/---/
<
\---\
>JACK======LED+LED
Signal -/
where signal is ~0V when leds flashes, and signal=9V in other case.
You need a "Ground+Signal" connection to inject IR into Xantech directly (when signal is ~6V when flashed, and 0 when quiet). This point IS inside of RFX, and you need a solder gun to re-configure RFX :)
| |
|
|
